0-10V Dimmer Module (L+N)

• 0-10 V analogue dimming output for LED drivers and ballasts
• One dimming channel
• 100-240 V AC 50/60 Hz, Live and Neutral required
• PIERRE Wave (Zigbee 3.0, 2.4 GHz)
• Overload, over-voltage, short-circuit, thermal, static and surge protection

The PIERRE Wave - 0-10V Dimmer Module (L+N) dims lighting by sending a 0-10 V control signal to the driver, rather than by chopping the mains waveform. That is the distinction to check before ordering: most commercial LED drivers, fluorescent ballasts and constant-current supplies expect 0-10 V, and will flicker or refuse to dim on a TRIAC dimmer.

The module is powered from 100-240 V AC 50/60 Hz and needs both Live and Neutral at the point of installation. It provides one dimming channel and communicates over PIERRE Wave (Zigbee 3.0, 2.4 GHz).

The housing is ABS+PC, rated IP20, sized to sit behind a switch plate in a standard back box or above the ceiling alongside the driver it controls.

Protection covers overload, over-voltage, short circuit, thermal, electrostatic and surge. Operating range is -10 °C to +40 °C at up to 80% RH.